Hello Michael,

is there a way to import the Code information into Jag3D from the .GSI format? I was searching through the forum but without success.

Kind regards
Nikolaj

Hello Nikolaj,

is there a way to import the Code information into Jag3D from the .GSI format?

Yes, it is possibel. In GSI files, the code is defined by the key 41. This key is extracted during the import of the file. Please check you GSI specification w.r.t. to the point code and the key as well.

All the best
Micha

Hello Micha,

thank you very much!

I wish you all the best und ein schönes Wochenende.

Nikolaj