Greetings MIcha,

I just have a question about the orientation aproximation. If not checked my adjustment is horrible (about 5 varians factor), if checked the same is less than 1. Now, in the resulting values displayed is says for 3 of them (after aproximating them) that their values are 359.xxxx values while the forth set is about 0.000xx. It cannot possibly be that from my configuration, so my question is does this parameter need to be enabled when evaluation direction sets? Say it is just a local network used for deformation analysis, on the other hand if doing hybrid adjustment on a large scale network with leveling data? I assumed that it is the value of the angle from the azimuth to the first orientation target, but it seems more to me like it is literaly aproximating the azimuth direction.

Best regards and thank you in advance.